Network Basics and Network Abstraction in Linux

Motivation

Before you learn the tools and commands for using the network in Linux you need a basic understanding of how networks work and this unit tries to bring you up to speed quickly.

The ISO-OSI 7 Layer Model

The 7 Layer Model is used to describe networks. The IP Protocol has not been developed within ISO and thus only roughly fits into the mode. Still it is a good picture to have in you mind when you think about networks.

On Top you have your applications. Like e.g. a Web-Browser. Below you need definitions on the details of how websites are encoded and transported via HTTP. And so on. And at the bottom we need specifications on how data is transmitted at the wire (or wireless): E.g. cable definitions, voltage levels, frequency, etc..

What we are looking at here is the Layer 2: That defines how data is encoded on a certain medium and in later units also layer3 (Routing - how packets are sent between networks).

Layer 2

From the abstraction in the operating system we basically have 2 different kind of physical medium:

broadcast

There is a local network where stations can send to each other and also there is a way to send to all stations on the network. Typically an ethernet network segment or a WiFi network.

point-to-Point

Two stations connected via a link and only those 2 stations can exchange data. Typically a dial-up connection, a network over a serial line or a virtual connection like a VPN tunnel.

The typical broadcast medium is ethernet and most network interfaces are of this type. In ethernet you have a 6 byte address that is used to address each station on the network. This is the so called hardware address or MAC Address. It is usually written in the form of 12 hex digits grouped into bytes by colons. E.g.: b0:35:9f:2a:29:7d. Each network card should have a unique MAC address. The first digits are assigned to a company and the last digits are counted up in the factory. The address mentioned belongs to an intel card.

In the old days the ethernet was built with a coaxial-cable that connected all computers. Today ethernet is usually built with twisted pair cables and RJ45 connectors. The cables run to a central switch or hub that distributes the packages to all stations. A hub would distribute every packet to every station. A switch is more intelligent: It learns the MAC address of each station and only distributes packets to the computer that was address. Of course, broadcasts are always sent to all station on that segment.

Most of the time we want to send TCP/IP packages. Those are encoded as payload within the ethernet frame. Within the TCP/IP there could be e.g. an HTTP request.