How Linux Boots

Motivation

Nothing is more frustrating then not being able to boot into your system. If it hangs a boot with a cryptic message, then what do you do? People running other Operating Systems then tend to try to re-install their OS at this point. Once you know how Linux boots then it is almost always possible to boot into your system again as long as your hard-drive is not damaged.

Stages of Booting Linux

Simplified:

1. your PC boots (BIOS from EEPROM chips on your motherboard. e.g when you press F12 during boot this is handled by the BIOS)
2. loads the first ca 300 bytes from block 0 of your hard drive
3. loads the rest of GRUB boot loader
4. GRUB can readonly mount most filesystems and load kernel (vmlinuz) and initial-ramdisk (initrd)
5. kernel unpacks itself and intializes hardware
6. kernel unpacks initial ramdisk and starts script there (e.g. /init )
7. initial ramdisk scripts loads additional modules and mount real /
8. starts init process. (today usually systemd)
9. systemd runs boot scripts for all configured items. (e.g. ssh, X11, ..) and mounts additional filesystems, ..

A few notes to the above:

• The BIOS is specific to PCs and this looks different on other hardware. E.g. Raspberry Pi and other ARM systems, etc..
• The initial boot blocks can also be loaded via network (PXE network boot).
• you can also directly boot a kernel without an initial ram-disk but that means that the kernel needs to have all necessary drives compiled in that are needed for at least reading the harddisk.
• systemd is still a bit controversial and there are distributions out there that try to avoid it. e.g. devuan.
• newer PCs support "UEFI/secure boot". Which does not offer much security but was intended to force the lock-in into proprietary operating systems. Most modern Linux Distributions can deal with UEFI-Boot but if you can turn this off in your BIOS settings it will make installing Linux much easier. For an overview of how the UEFI/SecureBoot works see: wiki.debian.org/SecureBoot
• when booting from CDrom there is a special syslinux bootloader used.

What can you do if your Linux does not Boot?

BIOS

When you do not even get to the Grub bootscreen then you have to check your BIOS. If you have more then 1 Harddrive you can select which one to use for boot and you can allow booting from CDrom or USB drive there. In some BIOS versions you can press F12 to select your boot device